T Post And Star Picket Fence Posts: Sizes, Weights And Ground Matching

Oct 31, 2026

Leave a message

T Post and Star Picket Fence Posts: Sizes, Weights and Ground Matching

Ask three suppliers to quote a star picket and the replies look identical on paper: 1.8 m, hot dipped, ten to a bundle. Then the posts arrive and they are not the same product. Two numbers decide everything - steel per metre, and zinc applied afterwards. Most failures we get called about trace to one of them.

This page covers the line post. It holds wire at height and resists sideways pull, and that is all it does. Corners, ends and gates need a strainer assembly; a picket pressed into that role leans inside twelve months. Read the sizes, judge your soil honestly, then order.

 

What a Star Picket Is: Rolled Section, Steel Grade and Zinc Coating

A star picket is rolled hot from billet, not folded from strip. The result is a stem with three flanges set roughly 120 degrees apart, which is why the same product travels under three names: T post in North America, star picket in Australia and New Zealand, Y post across much of Africa. Folded alternatives exist. They flatten under the driver.

 

The geometry matters because it puts steel away from the centre of the section, so the post resists bending whichever way the load arrives - a cow leaning, a branch dropping, a reversing truck. Down the web you will find holes punched every 75 mm to 100 mm, or raised studs, depending on whether the buyer clips wire on or hooks it. Check which version your crew expects before shipping. At the bottom sits a pressed anchor plate, usually around 100 mm square, welded or riveted on - small part, large consequence, since it is what stops the post being pulled up by frost or by a strainer tightening the line. Expect the top 20 mm to mushroom if you swing a sledge instead of using a driver cap.

Specification varies by market: North American buyers quote hot-wrought posts to ASTM A702, Australian tenders ask for steel to AS/NZS 3679.1 Grade 300 with hot-dip galvanising to AS/NZS 4680. Coating is quoted as mass per area - 300 to 600 g/m² is the usual requested band - not as microns. Write it that way on your enquiry and ask for mill and dip certificates together.

 

Finish is where the cost argument happens. Hot-dip galvanised costs more per piece and is the only sensible choice for a permanent fence. Bitumen-painted stock, the black pickets popular in West African markets, buys the same fence height for less money per container on temporary and semi-permanent runs - that part is legitimate. Do not put it into wet ground for twenty years. The coating gets torn by the driver going in, and rust shows at the driven top within one to two wet seasons.

Matching Length and Weight Grade to Your Ground Type

Shop it backwards: soil decides how deep you go, depth decides length, length and grade decide freight. Buyers who start at the price list end up with 1.5 m posts in coastal sand, wondering why the line waves.

Weight will not save you in the awkward case. In dry sand, pull-out resistance comes from depth and anchor plate area, so specify longer, not fatter, and pull spacing from 3 m to about 2 m. Firm loam forgives - a 1.8 m post driven 600 mm holds fine. Expansive black clay grips hard when dry and lets go when wet, so go deeper and plan to re-drive after the first wet season. Rocky or lateritic ground should stop the conversation: driving mushrooms the tip and twists the flanges, so dig and concrete an angle post instead.

 

Length Typical bury depth Light / 1.33 kg/m Standard / 1.58 kg/m Heavy / 1.90 kg/m Where it earns its keep
1.5 m 450 mm 2.0 kg 2.4 kg 2.9 kg Temporary fencing, silt fence on construction sites
1.8 m 600 mm 2.4 kg 2.8 kg 3.4 kg Rural wire fences on loam, hobby farms, general purpose
2.1 m 700 mm 2.8 kg 3.3 kg 4.0 kg 1.8 m mesh panels, sandy country, wind-exposed runs
2.4 m 800 mm 3.2 kg 3.8 kg 4.6 kg Corners and strainers, soft ground, river bank jobs

Piece weights are indicative, calculated from the unit weight plus roughly 0.1–0.2 kg for the anchor spade. Confirm against the factory datasheet before publishing prices.

 

Two readings from that table. Paying for heavy grade buys something only where there is load - mesh panels, anything above 1.8 m, anything stock pushes on - and a plain four-wire boundary in light country does not need it. Then there is the crew: standard 2.4 m at 3.8 kg a piece is fine all day, and heavy duty gets harder from hour six.

Wind deserves its own line. Mesh panels and chain link act as sails, and the load into each post rises faster than panel height does. In coastal or open country we would rather see a 2.1 m heavy post at 2.4 m centres than a light post every 3 m. Say so at enquiry stage if the run also carries razor wire topping.

Bundling, Container Loading and Driving the Posts

Star pickets ship in bundles of ten, steel-band strapped, loose-loaded or on timber. The timber route matters for one reason: wooden dunnage without ISPM 15 heat-treatment marking sits at the destination port until somebody pays for it. We have watched a three-day demurrage bill come out of a single unmarked pallet.

 

Loading is weight-limited, not space-limited. A 20GP carries roughly 22 tonnes of payload, and that arithmetic drives the table below - so moving standard to heavy grade can cost around 20 per cent of your piece count for no extra freight dollars.

 

Item Per bundle Approx. per 20GP
1.8 m standard (2.8 kg/pc) 10 pcs, ~29 kg 7,500–8,000 pcs
2.1 m standard (3.3 kg/pc) 10 pcs, ~34 kg 6,300–6,800 pcs
2.4 m heavy (4.6 kg/pc) 10 pcs, ~47 kg 4,400–4,800 pcs
1.5 m light (2.0 kg/pc) 10 pcs, ~21 kg 10,000–11,000 pcs

Estimated from payload only. Real figures depend on stowage, road limits at destination and whether mesh rolls ride in the same container.

Driving is mostly a question of the right tool: an 8 to 12 kg slide-hammer plus a cap protects the post top, and two people set a line much faster than one. Space posts 2.4 m to 3 m for wire, tighter where the ground is loose. Every 20 to 30 m you need a strainer assembly, and every corner needs one - a heavy 2.4 m picket with an angled stay, or an angle iron post concreted in. Skipping strainers is why fences go slack inside a year.

How much does one star picket weigh?

Unit weights cluster around 1.33, 1.58 and 1.90 kg/m for light, standard and heavy, so a 1.8 m standard post lands near 2.8 kg with its anchor plate. Multiply by ten for the bundle weight your forwarder will ask for.

What length should I order, 1.8 m or 2.1 m?

Finished height plus the bury depth your soil demands, and do not round down. A 1.5 m post gives you a 1.0 m fence in loam, short enough that sheep learn to clear it. Anything holding livestock starts at 1.8 m in our experience.

Galvanised or black bitumen painted?

Hot-dip galvanised for anything permanent or wet. Bitumen painted is legitimate for temporary fencing, events and price-driven markets, but it rusts at the driven top and at driver scrapes, so treat it as a finite-life product.

Can I use star pickets with welded mesh panels or chain link?

Yes, up to about 1.8 m panels, with heavy grade and 2.4 m centres. Taller than that, or heavy 358 security mesh, needs a round or square tube post. A picket lacks the bending stiffness for a tall sail, and extra zinc will not fix it.

Will star pickets hold cattle or horses?

For quiet stock behind four or five strained wires, yes, with proper strainers. For bulls, horses pushing, or crowding, no. A leaning 500 kg animal bends the section past useful, and a bent picket gets dug out, not straightened. Wooden or heavier strainers every 20 m change the answer.

What about frost-heave ground?

Drive below the frost line or the freeze-thaw cycle walks posts up, 20 to 40 mm a season in some Canadian clays. Where that is impossible, concrete the strainers and expect to re-drive line posts each spring.

Do you supply clips and driver caps too?

Clips, caps and wire ties ride along in the same container, and it is worth doing - freight is already paid and running short mid-job costs a day. Ask at quote stage so they land on the same packing list.

Tell us what you are fencing, what the ground does in winter, and how tall it has to be, and we will send back a length-and-grade recommendation with piece weights and a container estimate. Hebei Tengshan Wire Mesh ships T posts, star pickets, strainers and the accessories that go with them, mixed into one container if the job needs it. Send lengths, grades and coating spec to sales@tengshanmetal.com and we will quote against it.

Send Inquiry
Send Inquiry