A horse does not climb a fence. It leans on one, paws at one, rolls too close to one, and now and then goes over one. The name came out of American ranch fencing and undersells the product. What a 2x4 grid does is leave a hoof nothing to hook.
This page is about aperture and legs, not how the fence looks from the kitchen window. Gauge, roll weight, the gap under the bottom wire, and three cases where 2x4 welded mesh is the wrong buy - one of them a horse that kicks.
Why the Aperture Stops a Hoof, Not the Height
Geometry first. In a 2x4 mesh the horizontal wires run 50.8 mm apart and the verticals 101.6 mm apart, so each opening is roughly 100 mm wide and 50 mm tall. An adult hoof measures 120 to 130 mm across at the ground line. A foal's hoof at eight weeks is nearer 70 mm.
That one ratio decides the fence. A 70 mm hoof cannot enter a 50 mm slot. It can enter a 100 x 100 mm cell, and once the toe is in, the leg keeps travelling, the hoof twists, and 500 kg comes back against a trapped fetlock. Most leg injuries we hear about are not from jumping. They are from a hoof that went in and did not come out cleanly.
Pawing tells it from the other direction. A bored horse drags a toe down the mesh; on a 4 inch grid the toe catches a horizontal wire and the leg hyperextends behind it. At 2 inch spacing the toe slides off and the horse gives up. That is the whole mechanism.
Construction detail the catalogue skips. Every crossing is a resistance weld - about 190 per square metre, roughly 14,000 on a 1.5 m x 50 m roll - and each one burns the zinc back from a ring 2 to 3 mm across. That ring is where rust starts, which is why a cheap panel goes brown at the knots in year two while the wire between still looks new. Two ways out: pre-galvanised wire at 240 g/m² instead of the 60 to 90 that commodity mesh carries, or hot-dip the finished sheet for 8 to 12% more and accept a slight wave.
On gauge: 12.5 (2.5 mm) is the working standard. 10 gauge (3.4 mm) puts about 40% more steel into every square metre and is what boarding yards ask for. Below 2.0 mm the mesh survives weather and loses to a shod hoof, which is a different problem with a different bill.
Then the edge - cheapest safety decision on the fence, most often missed. A 48 inch roll finishes in cut wire at 1.2 m, a horse's shoulder and, with the head up, its eye. Ask for a looped edge or budget a top rail. Cut ends at that height open skin you will not find until the hair comes off.
Matching Gauge and Height to the Horse You Keep
Height gets over-argued. A fit 500 kg horse clears 1.2 m from a standstill, so 1.2 m is a boundary marker for ponies and quiet geldings, not a containment fence. 1.35 to 1.5 m is the working range. Stallions, youngstock in a small paddock and anything along a road want 1.65 m and up.
Post centres: 3.0 m on straight runs with 2.5 mm mesh, 2.4 m at corners and on slopes. Welded 2x4 does not stretch the way woven does, so it needs less tension - but it forgives less. One post leaning 20 mm pulls a whole bay out of line; there is no slack to take up.
| Animal and job | Height | Wire | Zinc | Post centres | Breaks first at |
|---|---|---|---|---|---|
| Pony paddock, quiet gelding | 1.2 m | 12.5 ga (2.5 mm) | 60-90 g/m² | 3.0 m | Weld knots, year 3-4 |
| General yard perimeter | 1.35-1.5 m | 12.5 ga | 120-240 g/m² | 2.7-3.0 m | Bottom gap, not the mesh |
| Stallion run, road boundary | 1.65-1.8 m | 11 ga (3.0 mm) | 240 g/m² | 2.4 m | Posts and braces |
| Boarding yard, heavy traffic | 1.5 m | 10 ga (3.4 mm) | 240 g/m², dipped | 2.4 m | Kicks, individual welds |
| Weanling pen, under 6 months | 1.35 m + rail | 12.5 ga | 120-240 g/m² | 2.0-2.4 m | Gap under the mesh |
Rolls: 50 m and 100 m.
Now the part most suppliers leave out. 2x4 mesh is not predator fencing. A fox passes a 100 mm gap without breaking stride, and a dog that wants in will dig the bottom gap open in an evening. If sheep or poultry share that fence line, this is the wrong product and no amount of gauge fixes it.
Second: with a confirmed kicker, welded mesh is the wrong construction. A shod hind hoof landing square on a weld pops it. Three or four knots gone and that bay loses its grid and sags into a hazard. Woven fixed-knot has no welds to pop - it bends and recovers. We make welded mesh, so weigh that as you like, but a kicker in a welded paddock is a repair every spring.
Third: for a foal under six months the danger is not the mesh, it is the gap underneath. A foal rolls, a leg slides under the bottom wire, and the fence becomes a lever. Turn the bottom 150 mm out and pin it, or run a rail. Same fence, different failure.
Tensioning, Ground Contact and How Rolls Ship
Set the bottom wire 25 to 50 mm off the ground on level going, and pick one strategy on undulating ground rather than half of each: follow the contour in shorter bays, or bury 100 mm. Doing both badly gives you a fence that touches in the hollows and floats on the rises, which is exactly where a hoof goes.
Strain against a braced corner post, not a line post. A 50 m roll at 1.5 m in 2.5 mm weighs about 85 kg - two people walk it out. The 100 m roll is around 170 kg and wants a jig or a spinner on a tractor. Pull until the verticals are straight, then stop. Welded mesh has no give in the nodes; two more clicks and the knots deform, the sheet oil-cans, and you have bought a fence that looks second-hand on day one.
Packing: HDPE-wrapped, ends capped, on timber dunnage, steel-strapped. A 20GP takes roughly 55 to 65 rolls of 1.5 x 50 m, and volume runs out before weight - the whole load sits under 6 t, so you are paying for air. Keep one roll length per pallet. A 50 m and a 100 m strapped together arrives oval, and an oval roll feeds crooked.
From Xingang, standard 2.5 mm 2x4 runs 20 to 25 days for a full container. 10 gauge and dipped sheet run longer, because they are scheduled rather than stocked.
Is 2x4 mesh safe for weanlings?
The aperture is. The installation often is not. At 1.35 m with 100 mm under the bottom wire, a weanling finds the gap before it finds the mesh. Add the rail or turn the bottom out and it is one of the safer options for youngstock.
Will it keep dogs and foxes out?
No. A 100 mm opening is a doorway for anything smaller than a labrador, and digging defeats it entirely. For predator pressure, run an electric strand off the mesh or specify a tighter aperture over the bottom 300 mm.
Green PVC or bare galvanised?
Green hides rust. The hiding is the problem: a popped weld under coating stays invisible until the wire hangs. Green also drops out of sight at dusk, from a horse's eye line. Galvanised reads brighter in low light and shows its failures early.
Do I need a top rail?
Not for the mesh. For the edge, yes, or order a looped finish. A bare cut edge at 1.2 to 1.5 m sits exactly where a shoulder and an eye travel when a horse spins away.
Can two rolls be joined mid-run?
Yes, with a tension bar and lacing wire at 150 mm centres, but put the joint at a post. A joint hanging in a 3 m bay is the first place a mesh fence sags.
How long will 2x4 last?
At 240 g/m² zinc, expect 20 to 25 years in rural air. At the 60 to 90 g/m² commodity level, 8 to 12, and the weld knots go first. Coastal salt air takes roughly a third off both figures.
Tell us the horse, the ground and the boundary, and we will quote a gauge and a height rather than a price per roll. Hebei Tengshan Wire Mesh runs 2x4 welded mesh in 12.5, 11 and 10 gauge at 1.2, 1.35, 1.5 and 1.8 m, in 50 m and 100 m rolls, looped edge on request. Send a photo of your worst post line - it saves a revision. Samples of 300 mm are free; the container is not.
